![]() If only adapter is specified, the current ISR Number is displayed. isr If build number and board number are specified, sets the ISR Number value in specified adapter. excl_memtrain_dtable When flashing on new VBIOS, a pre-determined memory training data table in the old VBIOS will not be overwritten. -pavbpn= Use with -pa command to update adapters of specific VBIOS PN.-pasvid= Use with -pa command to update adapters of specific SVID.-passid= Use with -pa command to update adapters of specific SSID.-padevid= Use with -pa command to update adapters of specific device ID.-logappend Logs and appends output to atiflash.log.-log Logs output to atiflash.log, overrides existing file.-scansii Overrides normal adapter detection to enable detecting SSI roms with/without TPI firmware.-siiuprog Specifies the GPIO Pin to be used as the uprog when updating SiI1930 microcontroller firmware.-siireset Specifies the GPIO Pin to be used as the Reset when updating SiI1930 microcontroller firmware.-keepprodsn keep the Prod SN on the adapter when flashing a new VBIOS.-keepisrsn keep the ISR Number on the adapter when flashing a new VBIOS.-atmel Use AT25Fxxx flashing algorithm regardless of ROMID straps.-st Use ST M25Pxx flashing algorithm regardless of ROMID straps. ![]() -sst Use SST25VFxxx flashing algorithm regardless of ROMID straps.-fp Force flashing bypassing BIOS P/N check.-fs Force flashing bypassing BIOS SSID check.-fm Force flashing bypassing BIOS memory config check.-fa Force flashing bypassing already-programmed check.AsicID & BIOS file info check OR boot-up card). -f Force flashing regardless of security checkings (e.g.-checkprodsn Comparing the Prod SN based on existing prod sn saved in ROM.-prod Set PROD number based on the given serial number if not specified, print out SN Number.-isr Set ISR number based on the given build and board number if not specified, print out ISR Number.bin command = - pa - padevid= 715 B infile exe banner = "Update v1.0" infile = a123. -mb Modify SSID, SVID, BIOS Pin Number, & Boot Message in BIOS image of adapter to values in.SSID & SVID in BIOS image of adapter is displayed if is not specified. -mi Modify SSID & SVID in BIOS image of adapter to.This command is the same as * -cb if is specified. -cr Calculate 16-bit ROM checksum for adapter and compare it to the specified.Checksum for the first kbytes of the ROM content is calculated if is specified. -cb Calculate 16-bit BIOS image checksum for adapter.Checksum for the first kbytes of the file is calculated if is specified. -cf Calculate 16-bit checksum for file.First kbytes (except for Theater in bytes) of ROM content is saved if is specified. -s Save BIOS image from adapter to file ` `.-pa Write BIOS image to all appropriate adapters.-p Write BIOS image in file to flash ROM in Adapter.-biosfileinfo Displays the Bios info in file.Display advanced information of adapter if specified. -ai Display advanced information of ATI adapters on system.Display information of adapter if specified. -i Display information of ATI adapters in the system.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |